BECHEM BERUFORGE 100

Coating lubricant for cold massive forming

Examples of Application
·  Complex parts in cold massive forming

Material
·  Steel
·  Stainless steel
·  Titanium

Properties
·  Aqueous suspension of solid lubricants
·  Produces very smooth surfaces
·  High forming degrees can be achieved

Characteristic data
·  Appearance : black

 

Evaporation residue

% 25 – 27

AA_003-153

Density at 20 °C

g/cm3 1.1 – 1.3

AA_003-9 acc. to DIN 51757

Efflux time at 20 °C

s 38 – 45

AA_003-121 acc. to DIN ISO 2431/4

pH value

11.0 – 11.5

DIN 51369

 

Instructions for use
·  Can be mixed with water in any ratio to adjust the desired service concentration
·  The required film thickness on the part surface depends on the desired degree of deformation and is adjusted via concentration
·  Residues can be easily removed with hot water
·  Storage : Container to be stored under dry and frost protected conditions. Temperature range +5 °C to +50 °C
·  Application

– The surfaces of the blasted blank parts are coated by dip application

– Parts are coated in the coating bath at temperatures between 75 °C and 85 °C in intervals for five minutes. Afterwards, if required, the parts are dried by means of hot air in intervals

– The coating bath can be heated up to 90 °C under constant circulation