BECHEM KUBRITRAC 4096-1

Fully synthetic high performance drawing oil

Examples of Application
·  Pre drawn tubes with initial dimensions up to approx. 54 x 2 mm
·  In and outside lubrication down to final dimensions of approx. 6 x 1 mm
·  The inside lubrication is mostly done according to the “single shot” method
·  The oil can also be pumped through the mandrel rod
·  Finning of copper tubes

Materials
·  Copper
·  Brass

Properties
·  Based on special esters which are resistant to aging and hydrolysis
·  Chlorine, sulphur or phosphorus free *

Characteristic data
·  Appearance : yellow, clear fluid

 

Density at 20 °C

g/cm3 0.85 – 0.87

AA_003-9 acc. to DIN 51757/5

Kin. viscosity at 20 °C

mm2/s 610 – 750

AA_003-133 acc. to DIN 51562

Kin. viscosity at 40 °C

mm2/s

270 – 330

Kin. viscosity at 50 °C

mm2/s

190 – 230

Flash point

°C ≥ 172

AA_003-125 acc. to DIN EN ISO 2592

Pour point

°C 0

AA_003-129 acc. to DIN ISO 3016

 

Instructions for use

·  Can be applied volume controlled in TOTAL LOSS ® procedure

·  In the following annealing process for hollows “ semi hard ” and finished tubes “ soft ” the remaining films evaporates practically residue free

·  Drawing oil remnants in relevant solvents can also be removed easily

·  Storage : Container to be stored under dry and frost protected conditions. Temperature range +5 °C to +60 °C

* Chlorine, sulphur or phosphorus are not part of the product formulation